Husqvarna 15V2 User Manual download pdf (Page 34)

32 – English

MAINTENANCE

Belt change on Combi 103

1. Remove the cutting unit.

2. Remove the front bolt from the parallel strut and

tip the strut backwards. Push the height

adjustment strut forwards.

WARNING!

Wear gloves to protect your

hands when working with the

blades.

3. Loosen the two bolts holding the protective hood

and then lift off the hood.

5. Ensure the blades are positioned as set out in

the diagram, at 90 degrees to each other,

otherwise the belt must be adjusted. When the

blade bearings are loose the belt can be moved

around to the next tooth.

Tighten the nuts enough so that the bearings

rest against the cutting hood but still can be

moved.

Tension the belt by turning the eccentric adjuster

on top of the cutting hood. Tighten the nut.

Tighten all nuts on the blade bearings.

6. When the belt can be moved 8 mm (5/16")

inwards using a force of 7 N (1.5 lb) the belt is

adjusted correctly.

7. Fit the protective cover over the belts and

replace the parall strut.

IMPORTANT INFORMATION

The blades on a BioClip unit should be

set at 90 degrees to each other. In all

other cases the blades can collide and

cause serious damage to the cutting unit.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

No comments

Husqvarna 15V2 User Manual Page 34