Husqvarna 15V2 User Manual download pdf (Page 35)

English – 33

MAINTENANCE

5. Fit the protective cover over the belts and

replace the parallelism arm.

Belt change on cutting unit with rear ejection,

side ejection and Combi 112

On these cutting units with “collision-proof” blades,

the blades are driven by one V-belt. Do as follows to

change the V-belt:

1. Remove the cutting unit.

2. Undo the bolt on the lift strut and the two screws

on the cover. Lift the cover off the cutting unit.

3. Loosen the spring (4) that tensions the V-belt

and pry off the belt.

Simply reverse the procedure to fit the new belt.

IMPORTANT INFORMATION

The blades on a Combi 103 unit should be

set at 90 degrees to each other. In all other

cases the blades can collide and cause

serious damage to the cutting unit.

4. Useful hint: Mark the positions of the blades on

the respective pulley using a felt-tip pen.

Loosen the three bolts 1/2 - 1 turn. Press the

sides of the belt together to give maximum slack

and tighten one of the bolts. Replace the belt

and tighten as shown (see decal on cover). Set

the blades at 90º to each other and loosen the

bolt again. The spring ensures the correct belt

tension. Check the positions of the blades again

and adjust if necessary by repositioning the belt

on the teeth. Tighten the three bolts to

45 Nm/32 lbft.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

No comments

Husqvarna 15V2 User Manual Page 35