MANUAL NO. 539106457 REV. IR (09/20/01)Operators Manual Models:968999117 / W3613ETS968999120 / W4815ETSPlease read these instructions carefully and ma
10AUXILIARY BLADE DRIVE BELT(48" MODELS ONLY)To adjust tension of the auxiliary belt rotate nuton linkage that is attached to deck strap locatedo
11Figure 6AUXILARY BELT ADJUSTMENT RODIDLER PIVOT POINTTURNBUCKLEENGAGEMENT IDLER ASSEMBLY1/4"BEFORE OPERATINGBe thoroughly familiar with all con
12STARTING AND OPERATINGENGINE: START ENGINE AS FOLLOWS:1. Move blade engagement lever to the offposition so the interlock will allow engine tostart.
13SERVICESERVICESERVICESERVICESERVICESERVICE ASSISTANCE -REPLACEMENT PARTSTo retain the quality of your mower, use genuineHUSQVARNA replacement parts
14CUTTER HOUSING SPINDLE ASSEMBLIESThe cutter housing assembly is designed with aslip fit inner race and pulley. The sole purposeof the setscrew in t
15WHEEL DRIVE BELT REPLACEMENTWHEEL DRIVE BELT: If belts are worn ordamaged, wheels will not drive properly. Toreplace either belt, proceed as follows
16Rear Tires ... Before Each Mowing ... Inflate to Proper PressureFront Tires ...
17Model Number:Serial Number:Date of Purchase:Dealer Information:Notes:
2Thank you for buying an HUSQVARNA! Before operating your new mower, read, understandand follow the important safety instructions and the other instr
3Table of ContentsSAFETY ... 4SETUP AND ADJUSTMENTS ...
4! WARNING ! : Failure to comply with the follow-ing instructions may result in serious injury tothe operator or other persons. The owner mustunderst
5MAINTENANCE1. Keep all nuts, bolts, and screws tight to keepmower in safe operating condition.2. Never store the mower with gas in the tankinside a b
6Setup & AdjustmentsGAS LINE INSTALLATION1. The gas line is factory installed on the engine.Attach loose end to fuel tank hose barb andsecure with
7AXLE ADJUSTMENTBOLTSPOSITION APOSITION BPOSITION CPOSITION DAXLE PIVOTBOLTSPLACE JACKHEREFigure 1REAR AXLE HEIGHT ADJUSTMENTLOOSEN BOLTS EACHSIDE
8CUTTING HEIGHT ADJUSTMENT CHARTAXLEPOSITIONNUMBER OFSPACERS BELOWCASTER ARMNUMBER OF 1/4" BLADE SPACERSUNDER CUTTER HOUSINGCUTTING HEIGHT(IN IN
9BRAKE / TRACTION ADJUSMENT1. Disconnect the brake linkage from the brakeband arm.2.With the mower in gear, place the drive leversin the drive positio
Comments to this Manuals