Husqvarna EZ24T/ 966659601 User Manual download pdf (Page 41)

MAINTENANCE

Adjusting the Mower Deck

Leveling deck

Adjust the deck while the mower is on a level

surface. Make sure the tires are inﬂated to the correct

pressure. See Technical Data under Transmission.

If tires are under or over inﬂated, the deck cannot be

properly adjusted.

The deck should be adjusted slightly higher in the

rear.

NOTE: To insure accuracy of leveling procedure,

mower deck drive belt must be installed prior to

leveling deck.

1. Wear heavy gloves. Turn each outer blade tip to

align front to rear with the deck (1) or side-to-side

(2).

2. Measure from the ﬂoor surface up to the bottom of

the blade tip on the discharge side of the mower

deck. Record the measurement.

3. Move to the opposite side, check that

measurement is the same. If adjustment is

required—with a ¾" or adjustable wrench, turn

the lift link adjustment nuts on either side counter

clockwise to lower or clockwise to raise. Adjust

until both measurements are equal.

8058-030

Lift link adjustment nut

8058-031

Deck front adjustment nuts

4. Turn any blade to align with the deck in front-

to-rear manner. If the front blade tip does not

measure

/8" to ½" higher in the rear—with a

or adjustable wrench, turn the nuts on the front

suspension linkage. Clockwise raises the front of

the mower, counterclockwise will lower the front.

Adjust nuts until rear of mower deck is positioned

level to

/8" higher in the rear than the side-to-side

measurement.

NOTE: This will place the mower deck in a

standard measurement position. Depending on

the type of grass being mowed or environmental

conditions, additional adjustments may be

required to achieve the desired cut.

8058-030

Align blades to begin measurements

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Comments to this Manuals

No comments

Husqvarna EZ24T/ 966659601 User Manual Page 41

Comments to this Manuals

Related products and manuals for Lawnmowers Husqvarna EZ24T/ 966659601