Husqvarna EZ24T/ 966659601 User Manual download pdf (Page 33)

OPERATION

Moving Machine by Hand

ZT-2800 Bypass Linkages

When pushing or pulling the mower, engage the

ZT-2800 bypass linkages. The ZT-2800 hydro release

levers are located on the rear of the frame, below the

rear engine guard.

1. Raise the deck into the highest cutting

position.

2. Pull the ZT-2800 release levers up and out of

the keyhole slots. Release the levers with the

head outside the frame and held in the bypass

position.

3. To re-engage the ZT-2800 to drive, reverse the

above procedure.

Load the machine into truck or trailer by driving up

ramps in low gear. DO NOT LIFT! The machine is not

intended to be lifted by hand.

8058-032

ZT-2800 engaged

8058-033

Bypass linkage, ZT-2800 locked in the bypass position

WARNING!

Use extreme caution when loading

the machine into a truck or trailer

using ramps. There is the possibility

of serious injury or death if the

machine falls off the ramps.

WARNING!

Make no adjustments without:

• the engine stopped,

• the ignition key removed,

• the parking brake activated

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 59 60

No comments

Husqvarna EZ24T/ 966659601 User Manual Page 33