Husqvarna LT120 User Manual download pdf (Page 22)

SERVICE AND ADJUSTMENTS

CABLES

NEGATIVE TERMINAL

POSITIVE TERMINAL

CHASSIS

CHARGED

BATTERY

POSITIVE TERMINAL NEGATIVE TERMINAL

FIG. 29

TO REPLACE HEADLIGHT BULB

• Raise hood.

• Pull bulb holder out of the hole in the backside of the

grill.

• Replace bulb in holder and push bulb holder securely

back into the hole in the backside of the grill.

• Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run

poorly, stop running, or prevent it from starting.

• Check wiring. See electrical wiring diagram in the

Repair Parts section of this manual.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The

fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig. 30)

• Raise hood.

• Unsnap headlight wire connector.

• Stand in front of tractor. Grasp hood at sides, tilt toward

engine and lift off of tractor.

• To replace, reverse above procedures.

FIG. 30

HOOD

HEADLIGHT

WIRE

CONNECTOR

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

(See Fig. 31)

The throttle control has been preset at the factory and

adjustment should not be necessary. Check adjustment as

described below before loosening cable. If adjustment is

necessary, proceed as follows:

• With engine not running, move throttle control lever

from slow ( ) to choke ( ) position. Slowly move

lever from choke ( ) to fast ( ) position.

• Check that holes “A” in governor control lever and hole

in governor plate line-up. If holes “A” are not aligned,

loosen clamp screw and move throttle cable until holes

are aligned. Tighten clamp screw securely.

GOVERNOR

CONTROL LEVER

GOVERNOR

CONTROL PLATE

CLAMP

SCREW

THROTTLE

CABLE

HOLES “A”

FIG. 31

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Comments to this Manuals

No comments

Husqvarna LT120 User Manual Page 22

Comments to this Manuals

Related products and manuals for Lawnmowers Husqvarna LT120