Husqvarna 340 User Manual download pdf (Page 37)

36 – English

Refit the carburettor. Screw in the carburettor bolts

directly from behind without lifting the carburettor

assembly, tightening to a torque of 1–1.5 Nm. It is

important to hold the carburettor flange securely

when tightening the bolts to prevent the inlet

manifold from moving.

Push down the rear carburettor mounting into the

rubber bushings using a small screwdriver. Re-

move tool 502 54 17-01.

Refit:

• cylinder, see special instructions

• silencer support (does not apply to 340, 345,

350)

• air filter

• HT lead

• cylinder cover

• after the test run retighten the silencer bolts to a

torque of 8–10 Nm

Repair instructions

Air intake system – refitting

Fit the inlet manifold (A) through the insulating

plate in the carburettor flange cut-out (B), and

check that the insulating plate’s impulse tube sits

correctly in the inlet manifold. Fit the perforated

brass support ring in the inlet manifold.

Position tool 502 54 17-01 between the carburettor

flange and the insulating plate.

Fit the air intake system on the cylinder and snap

the insulating plate into position. Check carefully

that the impulse tube is correctly seated against

the cylinder’s impulse channel.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

No comments

Husqvarna 340 User Manual Page 37