Husqvarna 340 User Manual download pdf (Page 25)

24 – English

Repair instructions

Generator – refitting

Feed the generator lead through the holes in the

crankcase and hand grip. Bolt the generator in

position, tightening the bolts to a torque of 5 Nm.

Clip the lead to the tank.

NOTE! The lead connector must be positioned on

the right of the clip, see diagram. Connect the lead

to the connector on the hand grip.

Refit:

• fuel tank with both stops and rear vibration

damping spring

• fuel hose to carburettor, hose length between

tank and crankcase: 43 mm/1.69 inches and

between crankcase and carburettor: 53 mm/2.09

inches

• throttle pushrod to carburettor

• flywheel with nut and washer

• cable guide, leads and starter assembly

Remove the piston stop and reconnect the HT lead

and cylinder cover.

Remove the fuel hose and throttle pushrod from

the carburettor.

Unbolt the rear tank mounting from the crankcase,

i.e. the rear vibration damping spring, and both

stops. Lower the tank as far as it will go to allow

access to the heater lead where it is connected to

the tank.

Disconnect the generator lead from the hand grip

and unclip it from the tank. Remove the generator

and lead.

Replacing the generator, model 346XP,

351, 353

Remove the cylinder cover. Disconnect the HT lead,

remove the spark plug and fit piston stop 502 54 15-

01 in its place. Take off the starter assembly, release

the leads from the cable guide and remove it.

Remove the cover from the hand grip.

Loosen the flywheel nut using a suitable socket

and unscrew it until it is flush with the end of the

shaft.

Position puller 504 90 90-02 over the magnets and

counterweight on the flywheel. Tighten 2–3 turns

and tap the head of the puller with a metal mallet to

release the flywheel. Remove the puller, nut and

washer. Lift off the flywheel.

Unscrew the two bolts from the generator but leave

the generator in place.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Comments to this Manuals

No comments

Husqvarna 340 User Manual Page 25

Comments to this Manuals

Related products and manuals for Petrol tool Husqvarna 340