Husqvarna 23 COMPACT User Manual download pdf (Page 7)

from heat and friction, and resists high

temperature thinning.

• Never use waste oil. _______

• stop the engine before removing caps.

Pill the oil tanK eacn tme tne ruei

tank is filled

Pull the starter rope quickly with your right

hand until the engine attempts to start,

then push the choke to the OFF position.

Pull the sorter rope quickly with your right

hand until the engine starts.

Allow the engine to run for approximately

five seconds. Then, release the throttle

trigger.

IGNITION SWITCH

T

Л

START (ON)

STOP (OFF)

STARTING

CHOKE

WARNING:Thechainmustnotmove

at idle speed. If the chain moves refer to

^MnOUnC I \Jn MUUUO IIVICI^ 1. /%VU1U \#Wl

with the muffler. A hot muffler can cause se

rious burns.

To stop the engine move the switch to the

STOP or OFF position.

To start the engine hold the saw firmly as

di iwwi I uciuw.

• Move switch to the STAHTpr ON position.

• Push Saw away with your nght hancl whil©

pulling starter rope with your left hand.

(Never reverse hand positions)

Hold saw firmly while pulling starter rope.

Lt¿гí.]

lltipWI 1С111Ъ I

When pulling the starter rope, do not use

the full extent of the rope as this can

cause the rope to break. Do not let starter

rope snap back. Hold the handle and let

the rope rewind slowly.

f~WI WWIVJ W90U 191 9Ш1 ui i^i ь w 19 mi

full choke; allow the engine to warm up

before squeezina the throttle trigger.

Do not cut materTal with the choReДast idle

lever at the FULL position.

For cold engine or warm engine after

running out of fuel.

• Position choke to the FULL position.

• Squeeze and hold the throttle trigger.

OFF

For a warm engine:

• Position choke to the OFF position.

• Pull the starter rope quicklywith your right

until Annina efarte

• i%u iw WfiMi M iw 1^11 tw «#Mau

• Squeezeandreieasethethrottletriggerto

allowing engine to idle.

Difficult starting or flooded engine:

I I 19 91 lyil 19 11 toy U9 IIV/WVJ9\J WIU 1 11IWWI I

fuel if it has not started after 10 pulls.

Flooded engines can be cieared of excess

fuel by following the warm engine starting

procedure listed above. Insure Ote ignition

switch is in the ON or start position.

MAI li^ nt illinn gta^Arlira r^i iik>. •• •

\JiCU UI UWUlU I9\^UII9 pwilll 1^

rope handle many times depending on how

badly the unit is flooded, lif engine fails to

start refer to the troubleshooting chart

CHAIN BRAKE

• This saw is equipped with a chain brake

designed to stop the chain if kickback oc

curs.

• The chain brake is activated if the front

hand guard is pushed forward, either

manu£ly or by centrifugai force.

• Ifthe brake is already activated, it is disen

gaged by pulling Jhe front^hand guard

back toward the front handle as ^ as

possible.

• When cutting with the saw, the chain

brake must disengaged.

Braking function contro!

Chain brake must be checked before each

use. Engage the chain brake with the saw at

idle . Accelerate to full throttle momentarily. If

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments