©HusqvarnaFOREST&GARDENOperator’s ManualModel: 23 CompactSafety RulesAssemblyOperationCare and MaintenanceWARNING:Read and follow all Safety Rules
collar from the trunk of the tree.LIMBING AND PRUNINGA WARNING: Never climb into a tree to limb or prune. Do not stand on ladders, platf
damage your chain and make cutting difficult.Replace your bar if bent or the inside rails of the bar are worn.• Clean the oil holes and bar
HUSQVARNAFOREST & GARDEN CO.WARRANTY STATEMENTEffective 02/95SECTION 1: LIMITED WARRANTYHusqvama Forest & Garden Comp2iny ("Husqvama
IMPLIED WARRAMTY ON THESE PRODUCTS EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FIT
FOR CALIFORNIA RESIDENTS ONLY WHENC’T'TT'TTTKT^ O I.IT>1 TT/~1T7« TTVT /~1 a T TT:i^T»'A.TX a Ovjr OlLiXVV Xl'^ »^-¿-VXjXJT WJ
WHAT IS COVERED—REPAIR OR REPLACEMENT OF PARTS—Repair or replacement of any warranted part will be performed at no charge to the owner at an
SAFETY RULESLook lor this symbol ^ to point out important safety precautions. It means: Attention! Become alert! Your safety is involved
z\/\ z__Xm^ WARNING: This chain saw can be dangerous! Careless orimr^rnnor I tCA 10A e>Ari^i te ¡p«it im« • ww I W«IW<99 <991IWW9 Wl
speed, there is greater chance of kickback occurring.• Use extreme caution when re-entering a cut.• Do not attempt cuts starting wit
CHAIN BRAKE & СКА ANGLEIk WARNING: The effectiveness of a chain brake in reducing operator injuries has not yet been fully determin
Turn the adjusting screw to move adjusting pin to the back. Further adjustment may be necessary as you mount the bar. Mount the ba
from heat and friction, and resists high temperature thinning.• Never use waste oil. _______• stop the engine before removing caps.Pill the o
chain moves have chain brake repaired by Authorized Service Dealer before use.Disengaged.^EngagedCUTTING METHODSIMPORTANT POINTS• Cut wood on
Hinge holds tree on stump and helps control fallOpening otfelling cutcontrol the direction of fall. Use wood or plastic wedges, but never s
Comments to this Manuals