Husqvarna YTH1542XP User Manual download pdf (Page 6)

HOW TO SET UP YOUR TRACTOR

CONNECT BATTERY (SEE Fig. 2)

CAUTION: Do not short battery termi-

nals by allowing a wrench or any other

object to contact both terminals at the

same time. Before connecting battery,

remove metal bracelets, wristwatch

bands, rings, etc.

Positive terminal must be connected

ﬁ rst to prevent sparking from accidental

ground ing.

• Lift hood to raised position.

• Open terminal access doors, remove terminal protec-

tive caps and discard.

• If this battery is put into service after month and year

indicated on label (label located between terminals)

charge battery for minimum of one hour at 6-10

amps.

• First connect RED battery cable to positive (+) battery

ter mi nal with hex bolt and keps nut as shown. Tighten

securely.

• Connect BLACK grounding cable to negative (-) battery

terminal with remaining hex bolt and keps nut. Tighten

securely.

• Close terminal access doors.

Use terminal access doors for:

• Inspection for secure connections (to tighten har

dware).

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use

the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Stan dard

wrench sizes are listed.

(1) 3/4" wrench (1) Tire pressure gauge

(1) 1/2" wrench (1) Utility knife

(2) 7/16" wrenches (1) 3/4" socket w/drive ratch et

(1) Pliers

When right or left hand is mentioned in this man ual, it means

when you are in the operating po si tion (seated be hind the

steer ing wheel).

TO REMOVE TRACTOR FROM

CARTON

UNPACK CARTON

• Remove all accessible loose parts and parts cartons

from carton.

• Cut along dotted lines on all four panels of carton.Remove

end panels and lay side panels ﬂ at.

• Check for any additional loose parts or cartons and

remove.

ASSEMBLY

FIG. 1

BEFORE REMOVING TRAC TOR FROM

SKID

ATTACH STEERING WHEEL (See Fig. 1)

• Remove locknut and large ﬂ at wash er from steering

shaft.

• Position front wheels of the tractor so they are pointing

straight forward.

• Slide the steering sleeve over the steering shaft.

• Align tabs and press steering sleeve ex ten sion into

bottom of steering wheel.

• Position steering wheel so cross bars are horizontal

(left to right) and slide onto steering wheel adapter.

• Secure steering wheel to steering shaft with locknut

and large ﬂ at wash er pre vi ous ly removed. Tight en

securely.

• Snap steering wheel insert into cen ter of steering

wheel.

• Remove protective materials from tractor hood and

grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN

SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO

ROLL OFF SKID.

143

STEERING WHEEL

INSERT

LOCK NUT

LARGE FLAT WASHER

STEERING WHEEL

STEERING

SLEEVE EXTENTION

TABS

STEERING

SHAFT

STEERING

SLEEVE

STEERING WHEEL

ADAPTOR

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Comments to this Manuals

No comments

Husqvarna YTH1542XP User Manual Page 6

Comments to this Manuals

Related products and manuals for Lawnmowers Husqvarna YTH1542XP