Operator and Parts ManualCollection SystemM-ZT 52 /966793002M-ZT 61 /966793003
10ASSEMBLY1. Remove the foot plate knob and foot plate. Set aside for later reuse.2. Remove and reserve the three rubber grommets from the foot rest
11OPERATIONTIPS FOR IMPROVED BAGGING• Follow the mower operation instructions in you mower operator manual.• When operating the grass catcher on a l
12BLOWER ASSEMBLYREPAIR PARTS1234567891011121314151719202122232425262728293031324434355937381646414243454748505040535455566558515663646562596066335860
13NOTE: ALL FASTENERS ARE GRADE 5 UNLESS OTHERWISE SPECIFIED.ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTIONREPAIR PARTSITEM PAR
14CHUTESREPAIR PARTS1234567891011125911811
15NOTE: ALL FASTENERS ARE GRADE 5 UNLESS OTHERWISE SPECIFIED.ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTIONREPAIR PARTS1.. 539
16BAGGERREPAIR PARTS12345678910111216151314151617
17NOTE: ALL FASTENERS ARE GRADE 5 UNLESS OTHERWISE SPECIFIED.ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTIONREPAIR PARTS1.. 532
18MOUNT, GUARD, BELTREPAIR PARTS1234567891011121315141916171821202517252526242728222322
19NOTE: ALL FASTENERS ARE GRADE 5 UNLESS OTHERWISE SPECIFIED.ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTIONREPAIR PARTS1.. 539
©2013 HTC. All Rights Reserved.Swainsboro, GA. Printed in U.S.A.CONGRATULATIONS on the purchase of a new collection system. It has been designed, engi
115 584027 Rev A 2013-02-15
CONTENTSTOOLS REQUIRED 7/16" Wrench or ratchet and socket 9/16" Wrench or ratchet and socket½" Wrench or ratchet and socket¾" Wren
4SAFE OPERATION PRACTICES FOR RIDE-ON MOWERSSAFETY RULESGENERAL OPERATION• Read, understand and follow all instructions in the manual and on the mach
5ASSEMBLY1. Remove the discharge chute from the deck by removing the side hardware from the chute bracket. Retain the hardware for reuse if the colle
6ASSEMBLY1. Make sure the tension release lever is forward (disengaged).2. Place the belt over the pulley on the deck. Refer to illustration for pro
7ASSEMBLY6 BAGGER MOUNT1. Using 1¾" round head shoulder bolts and nuts, attach the mount hitch to the mount tube as illustrated. Make sure the e
8ASSEMBLY1. Position upper chute support against bagger inlet, flush at outer edges. See Illustration.2. Using support as a template, drill two 3/8
9ASSEMBLY1. Slide upper chute onto middle chute, lining up the middle chute latch and the acorn nut on the upper chute.2. Stretch bungee latch up on
Comments to this Manuals