Husqvarna ProFlex 18 User Manual download pdf (Page 58)

56 – English

SERVICEJOURNAL

Work done

Pre-delivery service

1. Top up battery with acid and recharge for four hours.

2. Fit steering wheel, seat and any optional equipment.

3. Fit cutting unit.

4. Adjust cutting unit:

Adjust lift springs (effective weight of cutting unit should be

12–15 kg, or set to maximum lift if brush is to be fitted).

Adjust cutting unit so that rear edge is about 2–4 mm higher

than front edge.

Adjust cutting unit height setting so that cutting height limit is

5 mm above the frame of the unit at the lowest cutting height.

5. Check that the oil levels in the engine and transmission are

correct.

6. Check and adjust tyre pressure (60 kPa, 0.6 bar).

7. Connect battery.

8. Fill with fuel and start engine.

9. Check that machine does not move in neutral.

10. Check:

Forward drive.

Reverse drive.

Operation of blades.

Seat safety switch.

Lift lever safety switch.

Safety switch for the hydrostat pedals.

11. Check engine revs 3,000 ±75 rpm.

12. Tell customer about:

Need and benefits of following the service schedule.

Need and benefits of having machine serviced every 300

hours.

Servicing and the influence of this journal on the second-hand

value of the machine.

Range of applications for BioClip.

13. Complete proof of sale, etc.

Pre-delivery service carried out.

No outstanding problems.

Certified:

After first 8 hours

1. Change engine oil.

Date, mileage, stamp, sign

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

No comments

Husqvarna ProFlex 18 User Manual Page 58