Husqvarna HU800BBC User Manual download pdf (Page 15)

LAWN MOWER

TO ADJUST CUTTING HEIGHT

See “TO ADJUST CUTTING HEIGHT” in the Operation

section of this manual.

REAR DEFLECTOR

The rear deﬂ ector, attached between the rear wheels of

your mower, is provided to minimize the possibility that

objects will be thrown out of the rear of the mower into

the operator's mowing position. If the deﬂ ector becomes

damaged, it should be replaced.

TO REMOVE DRIVE BELT

If your mower does not operate properly due to suspected

drive belt problems, take your mower to a qualiﬁ ed service

center for repair and/or ad just ment.

TO ADJUST HANDLE (See Fig. 20)

The handle on your lawn mower has three (3) height posi-

tions - adjust to height that suits you.

1. Remove knob and carriage bolt on one side of the

lower handle.

2. While holding handle assembly, remove knob and

car riage bolt from opposite side, align hole in handle

with desired hole in handle bracket and reassemble

bolt and knob and tighten securely.

3. Align opposite side of handle with same positioning

hole and secure with bolt and knob.

CAUTION: TO AVOID SERIOUS INJURY,

BEFORE PERFORMING ANY SERVICE OR

ADJUSTMENTS:

1. Release control bar and stop en-

gine.

2. Make sure the blade and all moving

parts have completely stopped.

3. Disconnect spark plug wire from

spark plug and place where it can-

not come in contact with plug.

SERVICE AND ADJUSTMENTS

ENGINE

Maintenance, re pair, or re place ment of the emission con-

trol de vic es and sys tems, which are be ing done at the

cus tom ers expense, may be performed by any non-road

engine repair es tab lish ment or individual. Warranty repairs

must be performed by an authorized engine man u fac tur er's

service outlet.

ENGINE SPEED

Your engine speed has been factory set. Do not attempt to

increase engine speed or it may result in personal injury. If

you believe that the engine is running too fast or too slow,

take your lawn mower to an authorized service center for

repair and adjustment.

CARBURETOR

Your carburetor is not adjustable. If your engine does not

operate properly due to suspected carburetor problems,

take your lawn mower to an authorized service center for

repair and/or adjustment.

IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,

WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.

OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH

SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE

ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,

CONTACT YOUR NEAREST AUTHORIZED SER VICE CEN TER,

WHICH HAS PROPER EQUIP MENT AND EXPERIENCE TO

MAKE ANY NEC ES SARY ADJUSTMENTS.

FIG. 20

HANDLE

BRACKET

BOLT

KNOB

STORAGE

Immediately prepare your mower for storage at the end

of the season or if the unit will not be used for 30 days or

more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean

it thoroughly, remove all dirt, grease, leaves, etc. Store in

a clean, dry area.

1. Clean entire lawn mower (See “CLEANING” in the

Maintenance section of this manual).

2. Lubricate as shown in the Maintenance section of this

manual.

3. Be sure that all nuts, bolts, screws, and pins are se-

curely fastened. Inspect moving parts for damage,

breakage and wear. Replace if necessary.

4. Touch up all rusted or chipped paint surfaces; sand

lightly before painting.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments

Husqvarna HU800BBC User Manual Page 15

Comments to this Manuals

Related products and manuals for Lawnmowers Husqvarna HU800BBC