Husqvarna 128LD User Manual download pdf (Page 13)

English--- 13

115374327 Rev. 6 5/31/12

ASSEMBLY

A

Dismantling:

S Loosen the coupling by turning the knob.

S Press and hold the locking/release but-

ton (A).

S While securely holding the engine and

upper shaft, pull the attachment straight

out of the coupling.

Assembling and dismantling

the two--piece shaft

Assembly:

S Loosen the coupling by turning the knob.

S Position locking/release button (A) of

attachment into guide recess (B) of

coupling.

S Push the attachment into the coupling

until the locking/release button snaps

into the primary hole (C).

S Before using the unit, tighten the knob

securely.

S Fit the drive disc (F) on the output shaft.

S Turn the shaft until one of the holes in the

drive disc aligns with the corresponding

hole in the gear housing.

S Insert hex wrench (G) in the hole to lock

the shaft.

S Screw on the trimmer head (H) in the op-

posite direction to the direction of rota-

tion.

N

O

TE: Make sure unit is assembled cor-

rectly as shown in this manual.

Fitting the loop handle

S Position the handle on the upper shaft.

Note that the handle must be mounted

between the two arrows on the shaft.

S Fit the screw, securing plate and wing

nut as shown in the diagram.

S Tighten the wing nut.

D

E

D

F

G

H

S To dismantle, follow the instructions in

the reverse order.

Fitting the trimmer guard and

trimmer head (Model 128LD)

S Fit the correct trimmer guard (D) for use

with the trimmer head. Hook the trimmer

guard/combination guard onto the fitting

on the shaft and secure with the bolt (E).

B

A

C

W ARNING: All attachmen ts are

designedtobeusedintheprimary

hole unless otherwise stated in the

applicable attachment instruction

manual . Using the wrong hole could

lead to serious injury or damage to

the unit.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 70 71

Comments to this Manuals

No comments