Husqvarna 125C User Manual download pdf (Page 14)

14

STARTING AND STOPPING

Check before starting

S Inspect the unit before each use. Re-

place damaged parts. Check for fuel

leaks. Make sure all fasteners are in

place and secure. Make sure the cutting

attachment is properly installed and se-

curely fastened. Use only flexible, non-

metallic line recommended by the

manufacturer. Never use, for example,

wire or wire rope, which can break off

and become a dangerous projectile.

S Check that the trimmer head and trimmer

guard are not damaged or cracked.

Replace the trimmer head or trimmer

guard if they have been exposed to

impact or are cracked.

S Never use the machine without a guard

nor with a defective guard.

Starting and stopping

WARNING! The complete clutch,

clutch cover, and shaft must be

fitted before the machine is started,

otherwise parts could come loose

and cause personal injury .

Always move the machine away

from the refueling area before

starting. Place the machine on a

flat surface. Ensure the cutting at-

tachment cannot come into contact

with any object.

Make sure no unauthorized persons

are in the working area, otherwise

there is a risk of serious personal

injury . The safety distance is 50 feet

(15 meters).

Cold engine

Air purge: Press the air purge diaphragm

6 -- 10 times until fuel begins to fill the dia-

phragm. The diaphragm need not be com-

pletely filled.

Choke: Move the blue engine choke lever

over to the closed position.

S Clean the area around the

f

uel cap. Con-

tamination in the tank can cause operat-

ing problems.

S Ensure that the fuel is well mixed by

shaking the container before filling the

tank.

Starting

Hold the body of the machine on the

ground using your left hand (CAUTION!

Not with your foot!).

Grip the starter handle. Slowly pull out the

cord with your right hand until you feel

some resistance (the starter pawls grip);

then quickly and powerfully pull the cord.

Never wrap the starter cord around

your hand.

Repeat pulling the cord until the engine

attempts to start. Squeeze throttle trigger

to release the choke and pull starter rope

until engine runs.

NOTE: If engine dies, return blue engine

choke lever to the closed position and

repeat starting steps.

CAUTION! Do not pull the starter cord all

the way out and do not let go of the starter

handle when the cord is fully extended.

This can damage the machine.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments