Husqvarna 125C User Manual download pdf (Page 12)

12

ASSEMBLY

Fitting the trimmer guard and

trimmer head (Model 125L)

S Fit the correct trimmer guard (A) for use

with the trimmer head. Hook the trimmer

guard/combination guard onto the fitting

on the shaft and secure with the bolt (D).

Make sure unit is assembled

correctly as shown in this

manual.

Fitting th e loop hand le

S Position the handle on the shaft. Note

that the handle must be mounted be-

tween the two arrows on the shaft.

S Fit the screw, securing plate and wing

nut as shown in the diagram.

S Tighten the wing nut.

A

D

A

B

C

S Fit the drive disc (B) on the output shaft.

S Turn the shaft until one of the holes in the

drive disc aligns with the corresponding

hole in the gear housing.

S Insert hex wrench (C) in the hole to lock

the shaft.

S Screw on the trimmer head (H) in the op-

posite direction to the direction of rota-

tion.

H

S To dismantle, follow the instructions in

the reverse order.

Fitting the trimmer guard and

trimmer head (Model 125C)

S Fit the correct trimme r guard (A) for use

with the trimmer head. Hook the trimmer

guard/combination guard onto the fitting on

the shaft and secure with the wing nut (B).

A

C

B

S Fit the dust cup (C) on the shaft. The nut

must be completely covered by the dust

cup.

S Hold the dust cup with a wrench to pre-

vent the shaft from rotating.

S Screw the trimmer head (D) onto the

shaft.

S To dismantle, follow the instructions in

the reverse order.

D

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments