Husqvarna FS 800 EM User Manual

HUSQVARNA CONSTRUCTION PRODUCTSOperator’s manualFS 800 E FS 800 EMPlease read the Operator’s manual carefully and make sure you understand the instru

9. Technical specificationsThe table below gives the technical specifications for theFS800 E/EM floor saw. It is extremely important that youcheck the

11 _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

12Posn. no. Part no. Quantity Description Posn. no. Part no. Quantity Description83 531072183 1 Relay FS800 E 84 531072169 1 Two-position switch

13

14**************************Only for FS 800 EM*

www.husqvarnacp.com5040594-022007-06-07

2Compliance with EU directivesHusqvarna Construction Products Sweden AB, Box 2098, SE-550 02 Jönköping, Sweden, tel: +46(0)36-570 60 00, hereby certi

3Contents _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

4The FS800 E/EM floor saw is a professional machine designedfor cutting reinforced concrete, asphalt and stone.This machine may only be used by those

52. Safety precautionsYou must follow the safety precautions before starting themachine. If the user does not follow these precautions thenneither Hus

6• Check that the water-cooling coupling matches the speci-fications. See section 9 Technical specifications.• Set up a barrier or signs around the wo

7• Check your safety equipment and any protective clothingyou are wearing.• Apply the parking brake.• If the machine is fitted with a base plate (opti

8Figure 5.25.2.1. Water pipe for cooling blade5.2.2. Belt tension adjuster screw.5.2.3. Belt guardFigure 5.3Figure 5.45.4.1-2 Grease points for height

9Figure 6.27. Lifting and transporting thefloor sawThe FS800 E/EM floor saw is fitted with a parking brake, seefigures 7.2 and 7.3, which must be appl