Husqvarna LE389 User Manual

1Owner's Manual 601 00 22 32Reference No. 710386 10/08/961.1997Spare PartsPiéces Dètachées16

10GENERAL RECOMMENDATIONSThe warranty on this Edger/Trimmer does notcover items that have been subjected to op-erator abuse or negligence. To receive

11 CAUTION: Always stop the engineand disconnect the spark plug wire beforemaking any repairs to the Edger/Trimmer.SERVICE AND ADJUSTMENTSBelt

12LocknutBladeHoldingWrenchTighteningWrenchFIG. 3-SERV & ADJTO ADJUST CARBURETORThe carburetor shown below has been pre-setat the factory and read

13TROUBLE SHOOTINGCAUSECORRECTIONStale fuelDefective spark plugDrain fuel tank. Fill with freshfuelClean and re-gap or replaceTROUBLEDifficult startin

2SAFETY RULESTHESE SAFETY RULES ARE FOR YOUR PROTECTION. READ THEM CAREFULLY.IMPORTANTSafety standardsrequire operator presence controls to minimize

3WARNING: This unit is equipped with an internal combustion engine and should not be usedon or near any unimproved forest-covered, brush-covered or gr

4ASSEMBLY CAUTION: Always wear safetyglasses or eye shields while assemblingEdger/Trimmer.Fig.1-ASSY to the right shows the Edger/Trimmer comple

5• Attach the front wheels to the Edger/Trim-mer shown in Fig. 5-ASSY with a 5/16-18x 4.50 inch hex head screw, four 11/32 x11/16 inch flatwashers, t

6OPERATIONFASTFastSlowStopPrimer ButtonPRIMERKNOW YOUR EDGER/TRIMMERREAD THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUREDGER/TRIMMER. Co

7TO USE THROTTLE CONTROL• Run at full engine speed during normal use.• Push throttle control lever up to increasespeed; down to

8• Loosen T- knob on the inside right rearof the main frame that secures the wheelsupport rod as shown in Fig. 4-OP.• Slide the rear wheel down until

9TO START THE ENGINEBefore starting the engine, be sure you haveread and understood all the instructions onthe preceding pages. The Edger/Trimmer iseq