Husqvarna 136 User Manual download pdf (Page 13)

Before storing, drain all fuel from the unit.

Start engine and allow to run until it stops.

Clean the unit before storing. Pay particular

attention to the air intake area, keeping it free

of debris. Use a mild detergent and sponge

to clean the plastic surfaces.

Do not store the unit or fuel in a closed area

wher e fuel vapors can reach spar ks or an

open flame from hot water heaters, electric

motors or switches, furnaces, etc.

Store in a dry area out of the r each of chil-

dren.

TROUBLE CAUSE REMEDY

Engine will not

start or will run

only a few

seconds after

starting.

Ignition switch off.

Engine flooded.

Fuel tank empty.

Spark plug not firing.

Fuel not reaching

carburetor.

Move ignition switch to ON.

See “Difficult Starting” in

Operation Section.

Fill tank with correct fuel mixture.

Install new spark plug.

Check for dirty fuel filter; replace.

Check for kinked or split fuel line;

repair or replace.

Engine will

not idle

properly.

Carburetor requires

adjustment

Crankshaft seals worn.

Contact an authorized service dealer.

Air filter dirty.

Spark plug fouled.

Carburetor requires

adjustment.

Engine will not

accelerate,

lacks power,

or dies under

a load.

Clean or replace air filter.

Clean or replace plug

and regap.

Contact an authorized service dealer.

Engine

smokes

excessively.

Toomuchoilmixedwith

gasoline.

Empty fuel tank and refill with

correct fuel mixture.

WARNING:

Always stop unit and disconnect spark plug before performing all of

the recommended remedies below except remedies that require operation of the unit.

TROUBLESHOOTING TABLE

1 2 ... 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Husqvarna 136 User Manual Page 13

Comments to this Manuals

Related products and manuals for Tools Husqvarna 136