Husqvarna ZTH6125A User Manual

MANUAL NO. 539104771 REV.01 (05/23/00)Thank you for buying an HUSQVARNA! Before operating your new mower, read, understandand follow the important sa

10ADJUSTMENTSMOTION CONTROL LINKAGE ADJUSTMENT:1. This adjustment must be made with the drive wheels rotating. Raise rear of the unit andblock it up s

11OPERATING INSTRUCTIONS NOTE: To begin motion the operator must be in the seat and the brake disengaged beforethe levers can be moved from the neut

12OPERATING INSTRUCTIONSSTARTING AND OPERATION:1. Operator must be sitting in the seat. Engage park brake, blades off and place the motioncontrol leve

13MAINTENANCE1. Engine oil level: Check daily with engine cold and on a flat surface. Remove the dipstick and wipeclean. Reinsert the dipstick all t

14MAINTENANCE9. Tire pressure: Check every 25 to 50 hours. All four tires require 15 psi.10. Battery: Check every 25 hours. Check electrolyte level. I

15TROUBLE SHOOTINGPROBLEM POSSIBLE CAUSES Engine won’t start Mower will not move or moves slowly or hard1. Blade switch on.2. Drive levers not in

16WIRING DIAGRAM

17SERVICE RECORDDESCRIPTION OF WORK DONE DATESERVICE DONE BY

2Continuous dedication to improve our products require that specifications and design aresubject to change without notice.Congratulations on the purch

3TABLE OF CONTENTSSAFETY:1. Training2. Preparation3. Operation4. Transportation5. MaintenanceSETUP AND ADJUSTMENTS:1. Park brake2. Cutting height3.

4SAFETYTRAINING:1. Read this manual carefully and question your dealer if something is not clear.2. Be thoroughly familiar with the controls and prope

5SAFETYTRANSPORTATION:Use a heavy duty trailer to haul mower. Set park brake, turn off fuel valve and strap mower totrailer. NOTE: Park brake will n

6EQUIPMENT SETUP AND ADJUSTMENTS1. Uncrate mower2. Mount drive wheels using the four lug nuts installed on the hub.3. Check tire pressure in all fo

7ADJUSTMENTS PARK BRAKE:1. Stop engine and remove key. Release park brake and measure the length of the spring.The distance between the washers on

8ADJUSTMENTSMULE DRIVE BELT TENSION:1. Stop engine and remove the key.2. Check to make sure the bolt head in the spring loaded idler pulley, on the le

9Figure 5AFigure 5B5. If adjustment is necessary, loosen the nut against the yoke. Apply slight rearward pres-sure to the motion control lever and