Husqvarna DM 340 User Manual download pdf (Page 10)

10 – English

STARTING AND STOPPING

Before starting

Make sure that:

• Power switch, cord and electrical outlet are intact. If not,

they must be replaced by an authorised repairman.

• Cooling air vents are not blocked.

• The machine and its equipment are correctly installed.

• The stand is properly ﬁxed and that the drill is properly

mounted on the stand.

• The drill is secured properly.

• Water cooling is undamaged and connected to the

machine.

• Use suitable drill bits depending on whether water or dry

drilling is being performed. In the event of uncertainty

contact your dealer, your service workshop or an

experienced operator.

• Prevent unintentional starting. Ensure the switch is in the

OFF-position before connecting to power source.

Starting

1 Set the working speed by turning the drill spindle and at

the same time move the gear knob to the required

position.

2 Turn on the water cooling.

3 Start the machine by switching on the on-off switch.

Also press, if desired, the Smartstart

button.

Stopping

Switch the on-off switch off to stop the machine.

Cooling

Run the machine unloaded for a minute or two to cool the

motor.

WARNING! Note the following before

starting:

The machine should be connected to an

earthed outlet socket.

Check that the mains voltage corresponds

with that stated on the rating plate on the

machine.

Ensure you stand ﬁrmly. Keep people and

animals well away from the working area.

IMPORTANT! Changing gear may only be done when the

machine is switched off. Otherwise there is a risk of

damaging the gearbox.

WARNING! The drill bit continues to rotate

for a while after the motor has been switched

off.

Do not stop the drill bit with your hands.

Personal injuries can occur.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Husqvarna DM 340 User Manual Page 10

Comments to this Manuals

Related products and manuals for Tools Husqvarna DM 340