@ HusqvarnaOperator's ManualInstruction ManualRead and follow all Safety Rules and Operating Instructions before using this product.
wrist againstthe hand guard without releasing your grip around the front handle. The chain should stop immediately.Inertia activating fun
After removing the cutout of wood, make the felling cut on the opposite side of the notch. This is done by making a cut about two inc
BUCKING WITHOUT A SUPPORT• Overcut through 1 /3 of the diameter of the log.• Roll the log over and finish with a second overcut.• Watch for lo
SERVICE AND ADJUSTMENTü WARNING: Muffler is very hot during and after use. Do not touch the muffler or allow combustible material such as
CHAIN SHARPENINGChain sharpening is a complicated task that requires special tools. We recommended you refer chain sharpening to a pro
LIMITED WARRANTY STATEMENTSECTION 1: LIMITED WARRANTY Husqvama Forest & Garden Company C’Husqvarna”) warrants Husqvama product to the original pur
DEFINED IN THE LIMITED WARRANTY STATEMENT. HUSQVARNA RESERVES THE RIGHT TO CHANGE OR IMPROVE THE DESIGN OF THE PRODUCT WITHOUT NOTIC
purchase. WHAT tS COVERED: REPAIR OR REPLACEMENT OF PARTS. Repairer replacement of any warranted part will be performed at no charge
Husqvama Printed in U.S.A.
IDENTIFICATION (WHAT IS WHAT?1. Cylinder Cover ...13. Bar Tip Sprocket ... :2.Front Handle ... :14. Saw Chairi \3.Front Hand Guard
SAFETY RULES«»WARNING: Always disconnectspark plug wire and place wire where it cannot contact spark plug to prevent accidental starting when
Thereshould be nosmoking, open flames, or work that could cause sparks. Allowengine to cool before refueling.• Mix and pour fuel in an out
Symmetrical Guide Bar• Keep agood,firmgriponthesawwithboth hands when the engine is running and don’t let go. Afirmghpwillhelpyou reduce k
• Tip contact in some cases may cause a lightning fast reverse REACTION, kicking theguidebarupandback towa rd the operator.• Pinchin
Location of shipping spacerCuttersBar Clamp/ Chain BrakeBar Damp NutsBar ToolAn adjusting pin and screw is used to adjust the tension of the chain.
!f chain is too loose, turn adjusting screw 1/4 turn clockwise.Lift up the tip of the bar and tighten the chain brake nuts with the bar tool. Re
For cold weather starting, start the u nit at fu!! choke; allow the engine to warm up before squeezing the throttle trigger.NOTE: Do not cut
Comments to this Manuals