Husqvarna Rider 15V2 User Manual download pdf (Page 26)

24 – English

Checking and adjustment of the

steering wires

The steering is controlled by means of wires.

These can in time become slack, which implies that

the adjustment of the steering becomes altered.

Check and adjust the steering as follows:

1. Dismantle the frame-plate by releasing the

screws (two on each side).

MAINTENANCE

Adjusting the brake

The brake is adjusted as follows:

1. Release the lock nuts (1).

2. Tension the wire with the adjusting screw (2)

until all the play in the wire is taken up.

3. Tighten the lock nuts (1).

4. The brakes should be checked again after the

adjustment has been made.

WARNING!

Poorly adjusted brakes can result

in reduced braking power.

3. If necessary, the wires can be adjusted by

tightening the adjuster nuts on each side of the

steering collar. Do not tension the wires too

much, they should only be

tightened

against the

steering collar.

Support the wire so it does not twist.

If you tension only one side, the steering

wheel’s centre position may change.

Check the wire tension as set out in point 2

after you have made the adjustment.

2. Check the tension of the steering wires by

pushing them together as shown in the

diagram. It should be possible to push them

together so that the distance between them is

half as much, without using unnecessary force.

RIDER 850

6008-008H

6008-009

6008-010

6008-239H

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Comments to this Manuals

No comments

Husqvarna Rider 15V2 User Manual Page 26

Comments to this Manuals

Related products and manuals for Lawnmowers Husqvarna Rider 15V2